how to reset maintenance light on 2005 honda accord

How To Reset Maintenance Light On 2005 Honda Accord? The Maintenance Required light on your vehicle comes on after a specific mileage has been driven once the light has been reset. When this happens you will need to follow your owners manual and see what service is due for the mileage of the vehicle.

What does the maintenance required light mean on a 2005 Honda Accord? The Maintenance Required light on your vehicle comes on after a specific mileage has been driven once the light has been reset. When this happens you will need to follow your owners manual and see what service is due for the mileage of the vehicle.

Why is my maintenance required light still on after oil change?

If your maintenance required light is on. It’s because your car thinks it’s gone over a set amount of miles without changing the oil. If you’ve had your oil changed and it’s still on. That’s because whoever changed your oil didn’t reset the light.

How much oil does a 2005 Honda Accord take?

Engine Oil 4.4 quarts. . (with filter)After refill check oil level. 4.2 quarts. . . w/ofAfter refill check oil level.

What type of oil does a 2005 Honda Accord use?

Honda recommends using 4 quarts of their synthetic blend 5w-20 Motor oil.

How do you turn off the maintenance required light on a 2004 Honda Accord?

To reset your 2004 honda accord’s maintenance light, turn the key to the “on” position in the ignition and then turn it off. Depress the odometer trip -b? Button, and hold it down while you turn the key to the “on” position again. The light should go off.

How do I turn off the maintenance light after an oil change?

Hold the Reset Button and Turn the Key Turn the ignition back to the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.

How do you reset the maintenance required light on a oil change?

Push and hold the trip meter reset button on the dashboard, then turn your key to the second position. Continue to hold the odometer button for 10 seconds total. This should cause the light to flash, possibly beep, then turn off. After it’s off, release the odometer button then start the car.

How do you reset the dash light after an oil change?

Insert the key into the ignition and turn it to the “on” position without starting the engine. Depress the gas pedal slowly three successive times within 10 seconds. At this point, the system should have reset. You can verify by turning the ignition off and then on again.

Why is my maintenance light flashing?

It’s basically just telling you that your car will need some kind of scheduled service soon. It could be an oil change, a tuneup, or maybe you need a new timing belt. When the light begins to flash at startup, you have about 500 miles or so to go before the next scheduled service.

Where is the VSA button?

You’ll find it on the dash, to the left of the steering wheel. Press and hold this button until your hear a beep. The system will turn off, and the VSA Off light will turn on in the dash. Pressing and holding it (wait for the beep) will turn it back on.

Is it OK to drive with VSA light on?

If the VSA System Indicator lights up and stays on, it means there’s a problem with the system itself. … In the meantime, it’s perfectly safe to drive your car, but the VSA system won’t be there to protect you in difficult conditions, so it’s a good idea to drive with extra care until the problem is fixed.

Trafficautodriving Scroll to Top